Honda CBF1000/600 launch

Costa heads down to Georgia to sample some of Honda’s new 2010s. For our first instalment, let’s take a gander at the updated CBF1000 and new-to-Canada CBF600.

CBF1000 isn’t on the U.S. website.

Not many motorcycle manufactures can claim to offer more models in Canada than their counterparts in the much larger market south of the border. But Honda Canada can easily make such a claim by importing several Euro-spec models directly from Japan, instead of the usual route of piggybacking orders with American Honda.

Where Honda Canada sets precedent is in the number of Canadian-market models it imports; a visit to American Honda’s website reveals several omissions when compared to Honda Canada’s digital showroom. You won’t find the CBR125R, the Varadero, the CBF1000, or even the newly released CBF600 in the U.S.

I recently had the opportunity to ride both new CBF models around the streets of Savannah, Georgia, as well as at the Roebling Road Raceway, and I can say that both machines will complement Honda’s line-up quite nicely.

BIG BROTHER

2010 sees a complete redesign.

The CBF1000 has been in Canada since 2008, but is completely redesigned for 2010.

The 998 cc CBR1000RR-derived engine has been mildly retuned from last year’s model with a slight bump in compression ratio and a resulting increase of nine horsepower, now rated at 106 hp (still well down on the RR).

Though I found engine power to be more than adequate, litre-bike junkies will suffer as the high-rpm, adrenalin-inducing charge of an open-class supersport has been subdued to a more relaxed, entertaining stroll across the rev range.

Not the most powerful litre bike, but there’s enough for sport touring duties.

Although it doesn’t have the Bandit 1250’s brute bottom-end force, there is more than enough power for everyday chores like commuting or two-up sport touring (which will be easily accomplished once the accessory saddlebags are installed), with a broad, flat powerband and buzz-free cruising.

Shifting through the six speeds will put minimal wear on your left boot toe, as gear changes were light and positive, and the moderately light-effort clutch released smoothly with wide engagement.

Revised styling includes a frame-mounted half-fairing with a more aggressive nose that hints at the bike’s CBR1000RR heritage, and a four-position adjustable windscreen that can be adjusted while riding, though the owner’s manual clearly states you shouldn’t do this.

Old steel frame is dumped in favour of lighter aluminum jobbie.

Replacing the previous model’s steel frame is a lighter, rigid aluminum piece (saving five kg), onto which pivots a 41 mm telescopic fork and a single-shock swingarm made from rectangular-section steel. Suspension adjustments include front and rear preload, and new this year is rear rebound adjustability.

Suspension settings are on the firm side, which provided exemplary control at the fast, flowing Roebling circuit, but the trade-off is a slightly choppy ride over broken pavement.

High-speed handling at the track was remarkably settled, which came as a surprise after experiencing the bike’s effortless steering on the street. Steering effort was naked-bike light and neutral (thanks to the use of a 160-series rear tire), but the machine dove to maximum lean and held its line with the determination of an English Pointer.

Not a track-day bike, but it will lean.

Footpeg feelers touched at maximum lean, though nothing else – not even the centrestand. Of course, stickier rubber will probably allow hard-part-grinding lean angles, but this isn’t a bike I’d use at track days. Its racetrack handling was commendable, but it’s not a point-and-shoot type of bike, and kamikaze-diving to the apex is not its strong point.

Weighing in at a claimed 245 kg (540 lb) wet, the CBF1000 is nine kg less than the ABS-equipped Suzuki Bandit 1250 but 25 kg more than the Yamaha FZ1. At $12,999 it undercuts the FZ1 by $200, though the Fizzer doesn’t have ABS, while the CBF1000 has combined ABS as standard.

SIBLING RIVALRY

If a litre-class machine is too much for you to handle, you can opt for the CBF1000’s little brother, the CBF600.

Not as much a leap from a 125 as you may think.

Honda Canada has been aching to offer CBR125R owners an upgrade, only to see Kawasaki move in quickly to capitalise on the gap with their Ninja 250R.

According to Honda Canada’s Warren Milner, he’d have preferred a less intimidating, smaller displacement motorcycle than the CBF600 as a step up, but offering a 400-500 cc machine exclusive to Canada would have cost as much to import as the CBF600, and that cost would have put off potential buyers.

No matter, however, because the CBF600 is about as intimidating as Pee Wee Herman – and much less disturbing! Of note to CBR125R owners: with the CBF’s three-position adjustable seat (770-800 mm) set at its lowest, seat height is 10 mm lower than the 125’s.

Friendly ergonomics go with friendly motor.

Its 599 cc mill traces its roots to the CBR600F4i, but was mellowed to produce 76 hp and 43.5 lb-ft of torque. That puts it in the ballpark of the F650GS, FZ6R and Ninja 650R. At 222 kg (489 lb) wet it’s a bit heavier than those bikes, though it does carry 20 litres of fuel, which is more than any of them and should offer a good range.

Its street manners are very composed, with light controls and novice-friendly handling. At the racetrack, the CBF600 exhibited the same confidence-inspiring handling characteristics of the 1000 – only things happened slower.

I did one complete session following fellow journalists Bertrand Gahel (on another CBF600) and David Booth (on the CB1000R naked bike). Gahel and I were pinned trying to keep pace with Booth on the more powerful bike. He’d pull away on the front straight then we’d catch him in the twisty bits.

More fun than you’d think on the track!

Riding the CBF600 flat out was an exercise in line choice and momentum control. It was not unlike riding 125s, only much faster and as much fun. Losing just a bit of the drive out of a corner would have you scrambling through the next few turns to make up the lost ground.

The CBF handled Roebling’s fast, sweeping corners without a hint of instability, planted on a line until the rider chose to change it. The flowing course wasn’t conducive to hard trail braking, and under those conditions I think the CBF would have suffered.

As with the 1000, cornering clearance was ample for the racetrack and more than abundant for street riding; only the footpeg feelers bore the brunt of our on-track shenanigans.

Both models come with optional bags which will set you back a little over a grand.

Suspension compliance was on the firm side, though on Georgia’s smooth pavement, this helped handling. Longer time in the saddle on our roads will put the suspension to the ultimate test.

One drawback of having models exclusive to Canada is that they will be slightly more expensive than the direct competition. Honda Canada’s asking $9,899 for the CBF600, which puts it in the price range of Euro-bikes like the Triumph Street Triple, Ducati 696 or BMW F650GS.

You’d think it should be more in-line with the Kawasaki Ninja 650R, Suzuki GSX650F or Yamaha FZ6R, which are all about a grand cheaper, though only the Suzuki has standard ABS but in a non-linked system.

COMMON DENOMINATORS

What’s that then? I know I’ve seen one before but it was a while ago …

A comfortably upright riding position reinforced both these bikes’ all-round demeanour and was unmistakably reminiscent of the once popular UJM. A once-popular feature included on the CBF1000 is a centrestand ($239 option on the 600), and both bikes come standard with combined ABS.

Both machines have adjustable seat heights and windscreens (though tools are needed to lift the 600’s screen) and large, 20-litre fuel tanks. Suspension adjustment is limited to front and rear spring preload, though the CBF1000 adds rear rebound damping adjustability too.

Instruments are attractive yet spartan, offering minimal information – neither bike has a gear indicator.

These are not high-tech, high-performance rocket ships; they’re back-to-basics standards with highly satisfying performance at a reasonable price.

But then why bring these bikes to Canada when you can maintain the status quo, save a few bucks and leave big gaps in your line-up?

Because Honda Canada needs to fortify its line-up with accessible, easy-to-ride machines on which to build a new, younger customer base — and with these new CBFs, the company is several steps ahead of its American counterpart.

SPECIFICATIONS